Steve, do you have a suggested methodology for chasing down a situation in which some gear(s) are making a clicking sound, and sometimes the gear train is totally stopped. Yet when I run the gears by hand, I notice none of those things. Disclosure: the clock fell off a short table onto the floor, but I did not see any visible signs of damage. Prior to the fall, the clock ran flawlessly. thanks Mike
top of page
Note: Wix forums will be deleted on 15-Oct-2025 and moved to the tab labeled "Groups". Hopefully, it will be easier to use than the existing forum
Forum No Longer Supported by Wix.
Please Use Groups.
bottom of page
Something must have changed. It could be a gear in the back row shifting out of alignment. Or it could be a broken gear. Or a shaft might have been bent.
Probably best to take it apart and re-insert the gears again. That will give you a chance to inspect things and check that the back row is properly aligned.