• Home

  • Printed Clocks

    • SP1 Small Wall Clock
    • SP2 Large Wall Clock
    • SP3 Medium Wall Clock
    • SP4 Large Easy Build
    • SP5 32 Day Easy Build
    • SP6 Silent Desk Clock
    • SP7 Electromagnetic Clock
  • Wood Clocks

  • Future Designs

  • Forum

  • About Me

  • More

    Use tab to navigate through the menu items.
    To see this working, head to your live site.
    • Categories
    • All Posts
    • My Posts
    Greg Irving
    Nov 12, 2021

    Adhesion on larger gears

    in Printed Clocks

    I recently bought the design for SP6, which I think is beautiful. I've had no problem printing the base, motor mount, and even back frame piece. However, I'm really struggling with Gear 2--it took me awhile to get the first layer down properly, I've had more than a dozen failed prints. Now I'm able to get the first couple layers down but there are teeth sporadically around that start to peel up after only a few layers. Has anyone else experienced this? What can I do to help? I'm printing on an Ender 3 V2 with Hatchbox PLA filament. First layer Nozzle at 215C and Bed at 70C, next layers Nozzle at 205C and Bed at 60C.

    2 comments
    0
    Steve
    Nov 12, 2021

    I usually find the gears easy to print in this clock, especially when using enough perimeters to print without infill. I think 5 perimeters are needed with a 0.4mm nozzle for the size of gears in this clock.


    The gears start by laying down the spokes and half of the . Then each tooth starts as a small stripe that extends out and back from the rim. This initial gear tooth line should be continuous. Adjust the elephant foot compensation to make sure this first line is unbroken. Each line after that has something to connect to.


    All my other advice is generic. Adjust the Z height and make sure the bed is clean. Etc.

    0
    ksmietanski
    Nov 19, 2021

    Hi Greg,

    I print on an ender 5.


    I have had this problem on mine and it has always been associated with the adhesion of the first layer and this is usually associated with incorrect bed levelling and/or dirty bed.


    I usually run some isopropyl alcohol on my bed every now and then and also level the bed very carefully.


    On some of the smaller gears which do not have a lot of surface area for adhesion, I sometimes use blue painters masking tape on the bed. This has always great adhesion even to the point of making it difficult to take the printed piece off the printer.


    Hope that this helps.



    0
    2 comments

    ©2021 by Steve's Clocks. Created with Wix.com