Note: Wix forums will be deleted on 15-Oct-2025 and moved to the tab labeled "Groups". Hopefully, it will be easier to use than the existing forum

To see this working, head to your live site.

normhuntley

May 07, 2023

SB10

in Electric Clocks

Steve doing the SP10 clock is gear 3b_15 to mesh with gear 5b_25_10 and gear 1b_25_10 because it does not.

7 comments

7 Comments

Commenting on this post isn't available anymore. Contact the site owner for more info.

normhuntley

May 10, 2023

The controller was all ready programmed.

Steve

May 10, 2023

Replying to

It was already programmed, but still needs the jumper pins configured for your particular clock. It ships with all the jumper pins fully populated. Several jumpers will need to be removed to set the exact speed needed for your clock.

This thread also answers the same question and adds pictures. https://www.stevesclocks.com/forum/electric-clocks/silent-shield-board-pin-locations

Note: Wix forums will be deleted on 15-Oct-2025 and moved to the tab labeled "Groups". Hopefully, it will be easier to use than the existing forum

SB10

Forum No Longer Supported by Wix. Please Use Groups.

Forum No Longer Supported by Wix.
Please Use Groups.