I have some steppers from an Ender 3 Pro. These measure 6 ohms. Do you see any problem just adding 24 or 25 ohms in series with the windings to limit the current? Wondering if anyone has tried this?
top of page
Note: Wix forums will be deleted on 15-Oct-2025 and moved to the tab labeled "Groups". Hopefully, it will be easier to use than the existing forum
Forum No Longer Supported by Wix.
Please Use Groups.
bottom of page
Thanks. I was hoping the number of turns wasn't greatly different. Guess I'll just need to get the 30 ohm motor.