Finished setting up and configuring CNC shield SP6. Before installing it in the base, I tested it but the motor does not turn at all. I can hear is hum when I put it to my ear and can hear the pitch change when turning the pot on the driver.
I have tried several different jumper positions for the "direction and speed"
jumper block as is show in the picture (page 9 of the updated motor controller doc) I have attached a picture of my board showing just one of the many combinations I tried, FYI I removed the jumper on the left middle after taking this pic.
Also, the motor I have wiring colors are different than are on the instructions. Where the instructions show black, green, blue. red. the cable on my motor is black, green, red, blue. I tried switching the red. blue wires but nothing changed, Not sure if that is the problem or not.
Can you help me find what is wrong? Thank you
Thank you for letting me mail it to you. I know its probably something I did not get right. Let me know where you want me to send it. I will include a return label. Thank you again Steve,