This is my first time working on CNC Shield and related eletronics. I want to make sure I am doing the modfication (4 edits) correctly. Do you think you can share a picture of the backside of the CNC board after the modification? For example, I am not sure how to do Edit 2, Do i just short the four nodes on the right side, and connect the Vcc on the left to the top node on the right using a wire?
Thanks a lot,
Hi Steve,
Do I need to run the Adduino upload first before the rotor can be turned on? I tried to upload the clock_shiled.ino, and i selected the board and port, but I got this error below: avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 4 of 10: not in sync: resp=0x00