desktop clock SP6 motor rpm
I have the programmed driver from 'etsy and a completed 'sp6. I have a Stepperonline 17ME15-1504s stepper a 2 amp eer phase 0.9 motor 200 step.
None of the jumper setting give me a correct RPM
Your 11 May 2023 document say use 0011jumper for 3.6 RPm. this is way too slow.
The closest I can come is setting 5 06 6 which give 6.944 rmp. My clock needs a bit over 7 rpm to time correctly...
The motor cable is the same RedBlueGreenBlack at both ends.
I have plugged it into the connector nearest the edge of the board with the red lead closest to the USB.
It is turning a bit over 7 RMP.
??? what to do?
60 Views
Installed the 400 step motor...accurate to the second over night...happy clock builder.