Rolling Ball Clock
Just starting the Rolling Ball Clock. Couple of questions:
Purchased the build kit from Etsy. Will it have the proper arbor lengths to use the new clock face in the revised files?
The pin holes in the spiral auger are too tight for the pins. Using the 1/8" drill bit to widen them as suggested allows the pins to slide in but be a bit "loose". Once assembled will this looseness be an issue?
142 Views
I mistakenly ordered M3X25 threaded rod, I chuck them into my drill and screw them into one side, only drill the other part. Very little play and they don't fall out. I also got some carbon fiber tube which is a very tight fit. turned out very snug with no play.