top of page

Printed Clocks

Public·108 members

Steve Guberman
Steve Guberman

Balls getting stuck! Help!

I do not know why this is happening,

but the balls are continuously getting stuck, resulting in the clock stopping.


I even reprinted both parts for the upper feed.


I tried sanding and even soaking the ball bearings in alcohol to remove any coating or oil.


With the newly printed parts, it still happens.


It worked great for the first two weeks after I built it. Then this started happening.


Any ideas or suggestions?


Thanks!

Steve


105 Views
Slartibartfast
Slartibartfast
2 days ago
...even soaking the ball bearings in alcohol to remove any coating or oil.

I suspect having a little oil on your balls may actually help them not get stuck [trying to say that with a straight face: 😁].


When the balls are stacked up in the ramp, for them to move forward the two surfaces touching each other actually need to slide past each other in opposite directions. That is the "back" of the first ball needs to go "up" to roll forward while the "front" of the second ball needs to go "down". Given these two surfaces are in contact with each other, a thin layer of oil may actually help these two surfaces "slide" past each other, allowing the balls to roll together.


I understand the notion that oil may cause the ramp to "clog up", but if it's actually friction between the balls themselves that causes the blockage rather than the ramp itself, then the oil would most likely help. This would also explain why we're all developing this problem over time.

Members

©2021 by Steve's Clocks. Created with Wix.com

bottom of page