Coup Perdu Clock complete
I have completed the Coup perdu design and now have a working clock. Thanks Steve! I did find that some of the tolerances for the gears were quite tight and had to quite a bit of sanding where gears pass though other gears and through the Clock face hole .I did not have the issue with the 32 day clock
The tick is very loud! I only have a couple of coins in the motor to assist the reliability, Is there any way to make the coup tick a little quieter Steve ? Other wise my wife may relegate it to the spare room!
Thanks again for a great clock
clock
119 Views
I just posted my make of the deadbeat version. I had some trouble until I figured out the bearings in the front and back that support the pallet. It made almost no noise, but did not run, I added pennies to the motor holder and it was much nosier. I had no problem with tolerances, used Prusa 2.5 for slicing and printed on my Rat Rigs and Ender 5 Plus.