top of page

Printed Clocks

Public·67 members
Back
kicksnj2kicksnj2

REF: Redesign of SP7 Lower Pendulum Arm and Hex Screw

I have attached STL files with all the changes made for the SP7 lower pendulum arm. There are 3 different ways you can do it as seen in the photo. You must reprint out the lower pendulum arm for any of the changes. If you have any questions let me know. Also Steve you are more then welcome to include these in your SP7 files as alternatives. But it sure makes life easier changing the bob up or down :-)
I have attached STL files with all the changes made for the SP7 lower pendulum arm. There are 3 different ways you can do it as seen in the photo. You must reprint out the lower pendulum arm for any of the changes. If you have any questions let me know. Also Steve you are more then welcome to include these in your SP7 files as alternatives. But it sure makes life easier changing the bob up or down :-)

P.S. You will put the screw half way in the back cover of the Bob and then snap it in the channel opening in the lower pendulum arm and then screw the Bob together.


35 Views
120pilot
120pilot
Dec 30, 2025

Thanks for providing the files. Last night I started to model my own version of this in F360. But part way into it I noticed the scale was way off. I seem to recall that Steve models in inches and I usually use mm. I know there's a way to fix it since I've done it in the past. But last night I couldn't recall how. It was late so I decided to get some sleep and get back to it later. Now I can just download your files. Thanks again!


P.S. Hopefully this doesn't appear twice. My 1st attempt disappeared when I tried to add an emoji...???

Members

See All Members (67)

©2021 by Steve's Clocks. Created with Wix.com

bottom of page