top of page

General Discussion

Public·66 members

Michael Billington
Michael Billington

SP 15 Moon Phase Clock #d printed

I printed the smaller version of the Moon Phase clock.and with a few difficulties got it running well (getting the weight shell weight right was one of them). It ran for about 3 months reasonable accurately. THEN it stopped working and I spent days an days diagnosing an reprinting certain parts to no avail. I must have taken the clock apart so many times I lost count. It would run for a few seconds and then stop. I though maybe the cord for the weight was tangled so rewound it several times to make sure it wound on smoothly but again no luck. By this time I was ready to box it up and write it off as unsolvable. Until I had one last thought - reprint the escape wheel - so I did and straight away the clock started working again with excellent amplitude which tells me ethat PLA is susceptible to wear. I had often wondered how much wear could occur with 3d printed clocks and it appears that PLA wears quickly on the faster moving parts like the escapement. To me this means that PLA is not suitable for this part or the PLA I am using is not of good wear resistance. I am interested to know if anyone else has encountered this problem?

48 Views
normhuntley
2 days ago

I have been running the clock for a year printed with Polymaker PLA Pro it has never stopped, it is accurate to two minutes in a month. All five clocks I have printed with PLA with no problems.

Members

©2021 by Steve's Clocks. Created with Wix.com

bottom of page