Hi Steve, I gained weight now it works, thanks.

By swinging the pendulum like the other models of yours that I have purchased, the mechanism should be activated, I didn't understand your question...

Hi Steve, what do you think could be the problem? Thank you.

Hi Steve, I performed the test as per your instructions and the pendulum oscillates before stopping completely for almost 20 minutes, I completed the assembly with the weight of approximately 3,128 kg but it works for 5-10 minutes then stops, I can't understand what could be the problem, do you think I need to gain weight even if I'm over 3 kg?. Thank yo

ok thanks Steve, I'll try to follow some of your advice, especially the temperature, good advice. Thank you.

I have a Prusa mini

hi Steve, I have a problem, printing the Weight shell short 2p8, at the end of the 8 hours of printing there is a crack in the point you see in the photo, I printed another one but it has the same crack in the same point, in my opinion it is too thin you could look at us and if we ever change the design?. What do you think this problem could be? Thank you.

I printed the three rods you have in the file except the two optional pieces but I see that only one part of the center rod pendulum piece fits well with the top pendulum rod, the other end of the center rod pendulum with the lower rod doesn't do it, they don't fit together well, I've tried various pieces I don't understand why....

sorry I forgot the picture

Hi Steve, I printed pendulum Shaft lower and pendulum Shaft mid, but they don't match correctly see image, could you check the dimensions?. Thank you

Hi Steve, how do you print the gears?, top and bottom layers put 7 and 6?, 30% infill? , perimeters 4?, layer height 0.2 mm?. Thank you.

Hi Steve, I'm sorry but I can't quite understand the measurement in millimeters of the screws you use to assemble the pieces. example, Thank you

a ok did you mean the Brim, usually in the setting what do you put Brim only external or also internal?

Hi Steve, I didn't understand with the Italian translation what I have to set on prusa slicer where I highlighted you in red. Thank you.

Hi Steve, how much weight do you think it will take to make this watch work well?, how many kg does the model you printed work with?. Thank you.

OK danke.

hi Steve, I had the problem that as I explained to you in previous messages, the watch would stop after a while, I put some weight inside the mechanism container, now it doesn't stop anymore, but when the mechanism goes down before the lever it moves towards the magnet the pendulum slams against the lever 3/4 times then the lever falls towards the magnet and the mechanism rises again, what could it be?, in my opinion the pendulum has too much force and it slams, I remove a little of weight ?. thank you.

Hi Steve, I noticed that the coup perdu click goes for a period of time then suddenly stops, I don't understand why, maybe I have to put some weight inside the motor module?, I didn't put any weight inside it, it worked anyway but after about two weeks of operation now now and then I find it stopped. could you tell me the reason? thank you.