Assembly has started on the SP5B and should be ready to run later in the week.

Just A Heads Up The spacer file has a spacer that is not on the print plane and gives a print stability error. A big spacer, top right hand side needs to be set down on the same level as the others. In Prusa Slicer it was easy to seperate the parts and print that one by itself, but I have no idea about other software. Steve can likely repair the file and repost it. Cheers

Just a quick one ... I LOVE the running time numbers on some of the gears! Can we leave them on or will they throw out the balance of the gear? I am excited to get this one to run, Cheers

Thanks for that Steve. I am printing the whole thing. I have the big brother ticking away nicely for the last few months, and an SB5 that passes all the tests with flying colours but refuses to run. It did run flawlessly for seven weeks and then just quit and just refuses to go again. Oh well, stuff happens!

Thank You for that info. I was afraid that was the case. Cheers

I have now reprinted the clicks at 95% and installed them. The winding now is smooth and easy. Job Done! Thank You Steve.

Thanks Steve, I will do some at the 5% smaller. Cheers

That is a very interesting colour scheme on your clock. It looks like a good runner.

I also like the clocks. You have a very consistent colour scheme.

This is a nice looking clock! The colours go well together. I am currently building one of these as well.