top of page
Forum Posts
wagnmkr
Sep 10, 2024
In Printed Clocks
4.mov
0
0
12
wagnmkr
Aug 30, 2024
In Printed Clocks
Just a note to say that my 21 day, large skeleton clock is working fine at the moment. I had to take the pendulum bearings out and soak them again, but now it runs like a champ.
My only problem is that the clicks don't fit in the rachet very well (they seem to be too big) and it is quite hard to wind the clock. I printed them from the same clock file and am using the 10 day ratchet option. I now have three sets as I reprinted some more thinking they might be smaller.
I am very happy with how the clock runs and might do another one.
0
4
59
wagnmkr
Aug 30, 2024
In Printed Clocks
This is day three of the running of the Large, 21 day, Skeleton Clock and it is working fine. The beat is smooth and strong and the accuracy at this point is within a minute in 24 hours. I am making very small adjustments to the pendulum.
The only glitch to the making of this clock is that the clicks didn't fit in the ratchet very well and even without springs, it was very hard to wind. I sanded the ends of the clicks and it is OK now, but it still isn't as smooth and easy as the other versions of this part for the other clocks.
Still, a wonderful adventure into a different design and a very good running timepiece.
0
1
12
wagnmkr
More actions
bottom of page